0
0

Hi,

I am using T3-03 mixer and ADM-0126 as LO driver for LO of 1GHz.Please suggest input power level  range at ADM-0126 for optimum mixer performance.

What is the saturated output power of ADM-0126 without negative bias?

What is Noise Figure of ADM-0126 for frequency near 1GHz?

  • You must to post comments
0
0

Sorry for the delay.

The ADM-0126 will begin to saturate around +5 dBm input power, and will saturate completely with +10 to +15 dBm input power. This is where you should see the best T3 performance.

The saturated output power is not affected by the negative bias, so whatever value is on the curve in the datasheet should be representative.

The noise figure, however, is high at these low frequencies, around 8 dB or so.

  • You must to post comments
Showing 1 result
Your Answer

Please first to submit.

START TYPING AND PRESS ENTER TO SEARCH FOR MARKI PRODUCTS.